-
![Tensile Deformation Control of IMD In-Mold Film Molds]()
Tensile Deformation Control of IMD In-Mold Film Molds
IMD in-mold decoration molding integrates printed decorative films and molten plastics into one piece. During high-temperature injection, the film is affected by melt impact, cavity pressure stretchin
2026/07/17 Injection Molding
-
![Selection Reference Standard of Mold Steel for Modified Plastics]()
Selection Reference Standard of Mold Steel for Modified Plastics
Modified plastics with glass fiber reinforcement, flame retardant treatment and mineral filling have far higher wear, corrosion and high-temperature adhesion risks than ordinary plastics in injection
2026/07/17 Plastic Molds
-
![Customization Specifications of China Injection Molds for Industrial Equipment Accessories]()
Customization Specifications of China Injection Molds for Industrial Equipment Accessories
With the rapid development of China’s precision manufacturing industry, industrial equipment accessory injection molds have formed mature localized customization standards. Different from ordinary con
2026/07/16 China Injection Molds
-
![Selection & Replacement Standards for Mold Springs Suffering from Fatigue Fracture]()
Selection & Replacement Standards for Mold Springs Suffering from Fatigue Fracture
Mold springs bear reciprocating compressive loads during long-term production cycles. Excessive opening-closing frequencies, over-compression, and mismatched specifications are the primary causes of f
2026/07/16 Injection Mold
-
![Runner Design Standards for LCP Thin-Wall Molds]()
Runner Design Standards for LCP Thin-Wall Molds
LCP (Liquid Crystal Polymer) features ultra-low viscosity, fast solidification and strong shear sensitivity, widely used for 0.1–0.5 mm ultra-thin precision electronic parts. Unreasonable runner desig
2026/07/16 Injection Molds
-
![Development Detailed Specifications for High-Gloss Household Appliance Panel Molds]()
Development Detailed Specifications for High-Gloss Household Appliance Panel Molds
High-gloss mirror panels are widely used for home appliance appearance parts, requiring scratch-free, weld-line-free, orange-peel-free surfaces with ultra-high gloss. Mold development must follow stan
2026/07/16 Plastic Molds
-
![Source Prevention Measures Against Color Bleeding for Multi-Color Injection Molds]()
Source Prevention Measures Against Color Bleeding for Multi-Color Injection Molds
Color bleeding, speckles and mixed-color flaws on multi-color molded parts cannot be solved merely by adjusting molding parameters. Such defects mostly stem from mold structures, melt channels, meltin
2026/07/16 Injection Molds
-
![Calculation Methods for Cavity Compensation of Uneven Plastic Shrinkage]()
Calculation Methods for Cavity Compensation of Uneven Plastic Shrinkage
Plastic injection molded parts feature inconsistent shrinkage rates across different regions due to wall thickness variations, structural differences and uneven forming stress. Adopting a single unifo
2026/07/15 Plastic Molds
